Dimensional tolerance

dimensional range	General tolerance	Special tolerance
0～10mm	±0.25mm	±0.15mm
10～25mm	±0.30mm	±0.25mm
25～50mm	±0.50mm	±0.30mm
50～75mm	±0.80mm	±0.50mm
75～100mm	±1.00mm	±0.60mm
100～125mm	±1.2%mm	±0.70mm
125～150mm	±1.2%mm	±0.80mm
≧150mm	±1.2%mm	±0.7%mm

Angle tolerance

Angle range	General tolerance	Special tolerance
45°以下	±1.5°	±0.7°
45°以上	±1.5°	±1.0°

Surface finish

General finish	Special finish
S-35S	S-25S

contents of examination facilities

We are trying for stabilization and improvement of the quality with preparation for perfect inspection.

• Compression, low tension, bending, testing equipment
• Compression, low tension, bending, Repetition examination
• Non Destructive Inspection equipment
• Plating film pressure meter
• Torque examination device（push, pull, fastening）
• Hall measuring instrument